Intake Manifold Runner Control Vw Golf. I've had a cel for the intake manifold flaps (p2014) and instead of replacing the intake mani under warranty (even though i can't because td1), i was wondering about somehow. Replace failed vacuum lines or faulty vacuum solenoid (n316). You have to pull the intake box and unbolt your shift cables to replace the shifter and he might of unplugged something. If you are having issues with the intake manifold runner control motor, contact your local vw dealership. The only fault that showed up was intake manifold runner control p3138. I had a wee look on here and did a reset on block 142 intake. Hey guys, i just replaced my intake manifold on my 2008 tsi gti, and as soon as i started it, i had a p2008 intake manifold. Check intake manifold runner position sensor 1 (g336) and wiring, see repair manual. Check the vacuum line to the runner control vacuum pot / control valve (same line from the intake like diggs suggested).
from www.myturbodiesel.com
I've had a cel for the intake manifold flaps (p2014) and instead of replacing the intake mani under warranty (even though i can't because td1), i was wondering about somehow. You have to pull the intake box and unbolt your shift cables to replace the shifter and he might of unplugged something. The only fault that showed up was intake manifold runner control p3138. Check intake manifold runner position sensor 1 (g336) and wiring, see repair manual. Check the vacuum line to the runner control vacuum pot / control valve (same line from the intake like diggs suggested). Replace failed vacuum lines or faulty vacuum solenoid (n316). I had a wee look on here and did a reset on block 142 intake. If you are having issues with the intake manifold runner control motor, contact your local vw dealership. Hey guys, i just replaced my intake manifold on my 2008 tsi gti, and as soon as i started it, i had a p2008 intake manifold.
How to remove the intake manifold and EGR on VW Audi TDI 2.0L engine on
Intake Manifold Runner Control Vw Golf Hey guys, i just replaced my intake manifold on my 2008 tsi gti, and as soon as i started it, i had a p2008 intake manifold. I've had a cel for the intake manifold flaps (p2014) and instead of replacing the intake mani under warranty (even though i can't because td1), i was wondering about somehow. Check intake manifold runner position sensor 1 (g336) and wiring, see repair manual. Check the vacuum line to the runner control vacuum pot / control valve (same line from the intake like diggs suggested). Hey guys, i just replaced my intake manifold on my 2008 tsi gti, and as soon as i started it, i had a p2008 intake manifold. Replace failed vacuum lines or faulty vacuum solenoid (n316). You have to pull the intake box and unbolt your shift cables to replace the shifter and he might of unplugged something. If you are having issues with the intake manifold runner control motor, contact your local vw dealership. The only fault that showed up was intake manifold runner control p3138. I had a wee look on here and did a reset on block 142 intake.
